How to Use Mulch Glue
Mulch glue is a landscape adhesive that helps mulch stay put on slopes, along walkways, and in windy spots. The Harvest Company Mulch Glue is a concentrate that you mix with water and apply with a sprayer.
It works on mulch, pine straw, gravel, and other decorative ground cover. Once applied, it helps prevent the layer from shifting, washing away, or blowing out of place.
The glue is super-concentrated and mixes at a 1:3 ratio with water. The 1 qt size makes 1 gallon of mixed solution, so one container goes a long way.
Application rate, drying time, and the weather you need on the day are on the product label. Read it before you mix, and follow it over any general advice.
Same glue, different jobs.
Mulch glue is made for ground covers that tend to move. Here is how it fits the common ones.

From concentrate to a settled bed.
Check the label for the details on your container as you go.
Lay and level the mulch first
Spread the mulch, pine straw, or gravel to an even layer and rake out any thick or bare patches. The glue holds what is there, so shape the bed before you spray.
Work out how much glue you need
The 1 qt size makes 1 gallon of solution and covers approximately 125 sq ft. Measure the area so you mix enough for the whole bed.
Dilute the concentrate with water
Mix one part glue with three parts water, as the label directs, and stir or shake until blended. Mix only what you plan to spray.
Choose a suitable day
Read the label for the weather you need before and after application, such as rain and temperature. Pick a day that suits it.
Apply it with a sprayer
Spray the solution evenly over the surface, working across the bed in a steady pattern. Cover the edges and any slope where the mulch tends to move.
Give it time before foot traffic
Keep people and pets off the area for the time the label gives. Then check it after the next rain or windy spell.

A super-concentrated landscape adhesive that mixes at a 1:3 ratio with water and applies with a sprayer. It is made to keep mulch, pine straw, gravel, and decorative ground cover in place for residential and commercial landscaping.

Made in the USA from 100% recycled rubber, in a 1.5 cu. ft. bag (11.2 gal / 42.3 L). Suited to garden beds, walkways, playgrounds, and commercial landscaping.
What undoes a glue job.
These come down to preparation and timing.

Before you spray.
- 01Mulch glue helps keep mulch, pine straw, gravel, and decorative ground cover from shifting, washing away, or blowing out.
- 02It is a concentrate that mixes at a 1:3 ratio with water.
- 03Lay and level the surface first, then apply the solution with a sprayer.
- 04The 1 qt size makes 1 gallon and covers approximately 125 sq ft.
- 05The label sets the rate, the weather, and the set time.


Questions or notes? Drop them here.
A real grower replies within a business day.
No comments yet. Be the first.